Xref: utzoo comp.unix.sysv386:3259 comp.dcom.modems:7711
Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!swrinde!zaphod.mps.ohio-state.edu!julius.cs.uiuc.edu!apple!portal!cup.portal.com!cec
From: cec@cup.portal.com (Cerafin E Castillo)
Newsgroups: comp.unix.sysv386,comp.dcom.modems
Subject: Re: Problems with Everex<->T2500 CTS handshaking
Message-ID: <37115@cup.portal.com>
Date: 20 Dec 90 23:36:31 GMT
References: <1990Dec19.134211.2184@esleng.uucp>
Distribution: na
Organization: The Portal System (TM)
Lines: 29

I have seen this behaviour in relation to UART failures at above 9600 bps.
I would suggest that you lower your port speed to 9600 bps and test again.
I would also suspect the device drivers in your ISC UNIX.  Call ISC and
ask about this situation with the O/S, then call Everex and ask them about
their RTS/CTS flow control implementation.  I would also test using a
PC or UNIX system hooked-up with a null modem cable.  Run UUCP or Kermit
over this connection starting at 9600 bps and going up to 19.2 kbps to
see if a similar failure doesn't occur.  An RS-232 Protocol analyzer would
help with this kind of testing.  I suspect that the failure will be your
Everex multiport board and its drivers.  Oh, I forgot the obvious, if there
are any motherboard COMM ports (ie COMM1 / COMM2) attach the modem to
those ports and try your UUCP transfer as you are doing so now, on your
multiport board.  You might just see better RTS/CTS handling at 9600 and
19200 bps on COMM1/COMM2.  If not, then I would suspect the O/S and its
drivers.

Good Luck!

===============================================================================
Cerafin E. Castillo                       ||      //\\  ||\\  ||
Network Consultant                        ||     //__\\ || \\ ||  Los Altos
Los Altos Networks                        ||    // ---\\||  \\||  Networks
340 Second St. #6                         ||___//      \ |   \ |
Los Altos, CA  94022
(415) 941-8031      UUCP:     {apple,sun,uunet}!portal!cup.portal.com!cec
                INTERNET:     cec@cup.portal.com

                      "...No hay mal que por bien no venga..."
===============================================================================