Path: utzoo!attcan!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!samsung!munnari.oz.au!csc.anu.edu.au!manuel!ccadfa!prolix!dac From: dac@prolix.ccadfa.oz.au (Andrew Clayton) Newsgroups: comp.sys.amiga Subject: UUCP at 9600 Message-ID: <18626106.ARN00479@prolix.ccadfa.oz.au> Date: 18 Dec 90 13:02:30 GMT References: <3920@corpane.UUCP> <4647@disk.UUCP> Reply-To: ccadfa.cc.adfa.oz.au!Uprolix!Dac Followup-To: comp.sys.amiga Organization: I'm not an Organization - I'm a person! Lines: 54 (this is sort of a repost, since my article of four days ago generated nil response) In article , Sean Reifschneider writes: > > Sean > -- > From the desk of Sean Reifschneider. Isn't Amiga UUCP great? Thanks Matt. Amiga UUCP *is* pretty neat. I'm fishing for an answer to my problems encountered when using it though: I have a V32 (9600bps) modem, and it works fine talking to anyone at V32. Unfortunately UUCICO doesn't seem to be hacking the pace when I talk to my UNIX host at 9600bps. At 2400bps things are fine. At 9600bps, I get one, perhaps two, packets of mail (50K or so each), and then UUCICO gives up the ghost and calls Rmail to unpack the received packets. I have a 30Mhz 68030 so I wouldn't have thought processor speed was a problem. I purchased the ASDG dual serial card yesterday, and configured UUCICO to talk through that device. I STILL get the same problems. If I do anything at all whilst the transfer is going on (go to my editor, put a disk in the disk drive, do a LIST of UUSPOOL :-), then UUCICO gets out of sync with my host, and ceases to try and talk. This also happens spontaneously (like at the end of a packet, when it's writing the information to HD) I thought that ASDG board would solve my problems, but it hasn't. Next on my list is to have UUSPOOL: in RAM: instead of on HD (I've got about 7MB of ram available out of my 9Mb installed, so I should be ok there). I'm wary of this solution, because losing a session due to power outage would be traumatic. ************************************************************ * Does ANYONE else have problems running UUCICO at 9600bps!* ************************************************************ Since I can't use MAIL, replies via this newsgroup would be appreciated. Oh, and whilst I'm posting: Thanks to Roland Bless for ARN, which is a neat newsreader. Dac _l _ _ Andrew Clayton. I post . ccadfa.cc.adfa.oz.au!Uprolix!dac (_](_l(_ Canberra. Australia. . . I am. Note: I cannot send or recieve MAIL to sites outside of Australia. Sorry.