Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!uunet!lll-winken!sol.ctr.columbia.edu!caen!uflorida!mlb.semi.harris.com!trantor.harris-atd.com!trantor!kgreer From: kgreer@x102a.harris-atd.com (greer kl 01472) Newsgroups: comp.sys.ibm.pc.hardware Subject: PCjr CGA monitor Message-ID: Date: 17 Dec 90 19:32:58 GMT Sender: news@trantor.harris-atd.com Organization: Harris Gov't Aerospace Systems Division Lines: 19 Hello. I have an old PCjr video monitor that I want to hook up to a standard CGA video card. The problem is that the monitor cable has some seemingly non-standard rectangular-shaped connector and I do not have the pinouts. First of all, can this be done? I presume I can cut off the PCjr connector from the cable and solder on a standard 9pin. However, I need to find the pinouts of the monitor cable first. Can anyone out there offer some advice? Even better, would someone happen to know the PCjr monitor pinouts? Any comments or suggestions would be greatly appreciated. Thanks in advance. E-mail would be fine. -- ______________________________________________________________________ Kerry L. Greer Harris Corporation - GASD INTERNET: kgreer@x102a.ess.harris.com P.O. Box 94000 UUCP : uunet!x102a!kgreer Melbourne, FL 32902 ----------------------------------------------------------------------