Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!uunet!easy!lron
Newsgroups: comp.sys.amiga
Subject: Re: USR 14400/V42bis and Amiga
Message-ID: <186d1892.ARN08c6@easy.hiam>
Date: 27 Dec 90 01:08:18 GMT
References: <4240@mindlink.UUCP>
Reply-To: uunet!easy!lron
Followup-To: comp.sys.amiga
Organization: You must be talking about someone else.
Lines: 25
Expires:
Keywords:
Distribution:

In article <4240@mindlink.UUCP>, Raman Anand writes:

> I've just upgraded to the new USRobotics 14400 V42bis HST modem. I'm having
> problems downloading and uploading using V42bis (38400 baud)
> compression. I have used most of the popular PD/Shareware Amiga
> terminals and they all choke at bauds higher than 19.2k.
> Much to my surprise, Zterm0.85 (under AMAXII) works flawlessly at
> 38400 baud acheiving over 1650cps (Zmodem).
> I would like to know what (Real Amiga) terminals are people using
> with their HST14400/V42bis (or Dual) modems.

Well,  I've see what you mean.  I use JRComm, but I found if I wanted more than
2 colors I had to keep the serial port locked at 19.2.  The best program I know
of is AZComm,however make sure you have a version of serial.device that handles
CTS/RTS  flow  control  correctly  and make sure  the modem is set for a locked
DTE rate with full hardware flow control.  The init string for the modem should
look something like this: AT&B1&H1&I0&R2B1

There is a small  program called AmiModem  that will set up your HST modem like
this  as well as setting  some of the S-Registers for better dialing speed.

 -----------------------------------------------------------------------------
| Dwight Hubbard,                     |-Kaneohe, Hawaii                       |
| USENET: lron@easy.hiam or           |-GT-Power: 029/004              (lron) |
|         uunet!easy!lron             |-CFR     : 31:910/101 (Dwight Hubbard) |
 -----------------------------------------------------------------------------