Path: utzoo!censor!comspec!humvax!becker!hybrid!scifi!bywater!uunet!van-bc!sl
From: sl@van-bc.wimsey.bc.ca (Stuart Lynne)
Newsgroups: comp.unix.sysv386
Subject: Re: Intel HUB Serial Board
Message-ID: <1024@van-bc.wimsey.bc.ca>
Date: 21 Dec 90 00:23:11 GMT
References: <4624@iitmax.IIT.EDU> <1990Dec17.112731.3258@oct1.UUCP>
Distribution: usa
Organization: USENET Public Access, Vancouver, B.C., Canada
Lines: 29

In article <1990Dec17.112731.3258@oct1.UUCP> mason@oct1.UUCP (David Mason) writes:
>In article <4624@iitmax.IIT.EDU> thssdwv@iitmax.iit.edu (David William Vrona) writes:
>>Does Intel still make the HUB 6 port serial board?  I am looking for an
>>inexpensive UART based multiport board that is compatible with FAS, i.e. one
>>interrupt for the entire board (non-sharable).  Anyone have a used HUB to sell?
>
>Only just.  Intel is stopping taking orders for the HUB-6 on 31/12/90. 
>Last deliveries 6/91.
>
>I am not sure that FAS will drive the HUB-6.  I have a HUB-6 and a
>serial port with FAS in my system, and FAS does not see the HUB-6 -
>but I have not told it to look for it.  If I were you I would try before
>you buy.

Without special handling I doubt that FAS would handle the HUB6. It has an
incompatible method for accessing the UARTS.

Basically if memory serves .. you have two I/O addresses. You output the port number
and the UART register number to the first port and then read/write to the second
port. Suprisingly this does not add a very large amount of overhead to the driver if
done right.

If anyone is really interested I can dig out details. Assuming that FAS can be
convinced to handle the I/O like that it would be able to handle the HUB6. And I
have also put 16550's on a HUB6 without problems.

-- 
Stuart Lynne	Unifax Communications Inc.
		...!van-bc!sl 604-937-7532(voice)     	sl@wimsey.bc.ca