Path: utzoo!utgpu!news-server.csri.toronto.edu!rutgers!soleil!helix!gopstein
From: gopstein@helix.squibb.com (Rich Gopstein)
Newsgroups: sci.electronics
Subject: Re: replace Norelco shaver battery?
Message-ID: <1126@soleil.UUCP>
Date: 28 Dec 90 16:11:04 GMT
References: <17100010@inmet>
Sender: news@soleil.UUCP
Reply-To: gopstein@helix.squibb.com (Rich Gopstein)
Organization: Bristol-Myers Squibb PRI, Lawrenceville, NJ
Lines: 20

In article <17100010@inmet> mep@inmet.inmet.com writes:
>
>The battery in my Norelco shaver (950RX) is taking less & less of a charge.

I just replaced the two batteries in my Norelco shaver.  I don't
recall the model number of the shaver, but I would be surprised
if yours has a different size battery.

The batteries that you need to get are sub-C Ni-cads.  Prices varied
greatly, from about $3.00 per cell to over $7.00.  Make sure that you
get cells with solder tabs which will make it MUCH easier to connect
the new cells to the shaver.  Be certain to connect the new cells with
the same polarity in the circuit as the old cells.  Otherwise the
shaver will run backwards.

--
Rich Gopstein

gopstein@squibb.com
rutgers!squibb.com!gopstein