Path: utzoo!utgpu!news-server.csri.toronto.edu!rutgers!cs.utexas.edu!uunet!maverick.ksu.ksu.edu!matt.ksu.ksu.edu!kodiak
From: kodiak@matt.ksu.ksu.edu (Bryan D. Nehl)
Newsgroups: comp.sys.ibm.pc.hardware
Subject: settings for adaptek rll controller
Message-ID: <1991Jan4.074534.20209@maverick.ksu.ksu.edu>
Date: 4 Jan 91 07:45:34 GMT
Sender: news@maverick.ksu.ksu.edu (The News Guru)
Distribution: usa
Organization: Kansas State University
Lines: 18

Does anyone know what the jumper settings should be for the Adaptek ACB-2071
XT RLL controller card giving the following configuration:

1 seagate st238 32meg hard disk configured as drive select 2.
	resistor pack in place at the end of a twisted cable.

Also, what is the address for the onboard ROM firmware?

thanks.

Bryan.

(913) 776-0210 or (913) 776-5959
/* ==== Bryan Nehl ===== kodiak%kodiakpc.uucp@phobos.cis.ksu.edu ====+
[   Big Bad Beastie Bears             ][ kodiak@matt.ksu.ksu.edu     ]
[   kodiak@Kodiakpc.Manhattan.KS.US   ][ bdn@phobos.cis.ksu.edu      ]
+__________ ...!rutgers!ksuvax1!matt.ksu.ksu.edu!kodiak ___________ */