Path: utzoo!utgpu!cunews!bnrgate!brtph3!brchh104!brchs1!bnr.ca!rice.edu!sun-spots-request
From: fedor@dsg.csc.ti.com (Lee Fedor)
Newsgroups: comp.sys.sun
Subject: Sun and TI microlaser
Keywords: Hardware
Message-ID: <1068@brchh104.bnr.ca>
Date: 4 Jan 91 21:16:54 GMT
Sender: news@brchh104.bnr.ca
Organization: Sun-Spots
Lines: 24
Approved: Sun-Spots@rice.edu
X-Sun-Spots-Digest: Volume 10, Issue 9, message 1
X-Note: Submissions: sun-spots@rice.edu, Admin: sun-spots-request@rice.edu

Are you still having trouble getting your microlaser to work on your Sun?

I have one connected to serial port a of a 4/330 running 4.1 OS and
transcript 2.1.  The printer is set up to run postscript and my printcap
entry looks like this:

0|lp|lw|ps|postscript|PostScript:\
	:lp=/dev/lw:sd=/usr/spool/lw:\
	:lf=/usr/spool/lw/lw-log:af=/usr/adm/lw.acct:\
	:br#9600:rw:fc#0000374:fs#0000003:xc#0:xs#0040040:mx#0:sf:sb:\
	:if=/usr/tran/sparc/lib/psif:\
	:of=/usr/tran/sparc/lib/psof:gf=/usr/tran/sparc/lib/psgf:\
	:nf=/usr/tran/sparc/lib/psnf:tf=/usr/tran/sparc/lib/pstf:\
	:rf=/usr/tran/sparc/lib/psrf:vf=/usr/tran/sparc/lib/psvf:\
	:cf=/usr/tran/sparc/lib/pscf:df=/usr/tran/sparc/lib/psdf:

The printer itself should be set to ps and TI-net, then set to rs242, with
baud rate at what you wish, and parity set to none, stop bits set to one,
and start bits set to 8.  I think that is everything you will need.

Regards,

Lee Fedor
System Administrator                             fedor@dsg.csc.ti.com