Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!usc!sdd.hp.com!news.cs.indiana.edu!bronze!venus.iucf.indiana.edu!graham
From: graham@venus.iucf.indiana.edu (JIM GRAHAM)
Newsgroups: comp.sys.amiga.hardware
Subject: BaseBoard software installation...
Message-ID: <1991Jan14.160905.756@bronze.ucs.indiana.edu>
Date: 14 Jan 91 19:00:21 GMT
Sender: news@bronze.ucs.indiana.edu (USENET News System)
Reply-To: graham@venus.iucf.indiana.edu
Distribution: na
Organization: Indiana University Cyclotron Facility, Bloomington, Indiana
Lines: 26
News-Software: VAX/VMS VNEWS 1.3-4

I recently installed a BaseBoard in my A500.  It all works perfectly,
however, I have a couple of questions concerning the software.

1.) The documentation mentions nothing about fastmemfirst.
    Do I still need to use this program in my startup-sequence?

2.) The docs say to put cRam just before the "loadwb delay" line
    in the startup-sequence.

    a.) Why at this particular point?
    b.) What if I'm not using workbench at all.  Where should it
        go, then?

Thanks for any help,
-Jim


-> ->Disclaimer: I'm not ashamed of what I say. <- <-
     Sorry if the above disclaimer is too long.
 ______________________________________________________________________
| Internet: graham@venus.iucf.indiana.edu                              |
| UUCP:     dolmen!graham@iuvax.cs.indiana.edu                         |
| FIDO:     Soon!                                                      |
| BBS:      The PORTAL DOLMEN BBS/ParaNet ALPHA-GAMMA (sm) (9:1012/13) |
|           (812) 334-0418, 24hrs.                                     |
|______________________________________________________________________|