Path: utzoo!utgpu!news-server.csri.toronto.edu!rutgers!cs.utexas.edu!swrinde!elroy.jpl.nasa.gov!ames!uhccux!waikato.ac.nz!atc From: atc@waikato.ac.nz Newsgroups: comp.sys.atari.st.tech Subject: how about an upgrade to 68010 Message-ID: <1991Jan13.180628.2676@waikato.ac.nz> Date: 13 Jan 91 05:06:28 GMT References: <1991Jan7.232807.44220@vaxb.acs.unt.edu> <2509@sparko.gwu.edu> Distribution: usa Organization: University of Waikato, Hamilton, New Zealand Lines: 42 In article <2509@sparko.gwu.edu>, kilian@seas.gwu.edu (Jens Kilian) writes: > In Article 1068 of comp.sys.atari.st.tech, kenc@vaxb.acs.unt.edu writes: > >> Chris, >> This is a no go, because of the way that the CPU and the MMU swap cycles. >> >From what I understand, the system clock ALREADY runs at 16 Mhz, but it gives >> half to the 68000, and half to the MMU. (I may have the wrong chip...it may be >> the glue...) >> Anyway, since THAT chip, and all the support chips are not rated at anything >> like 16 Mhz, and all the timing is sensitive, you try to double the speed of >> the system clock, and you have an expensive paperweight. >> I think the speed up kits available use a caching technique, so that the new >> chip DOES run at 16 Mhz, for it's cache, and 8Mhz for anything else. That way, >> you do get the speed improvement, and the system timing doesn't change. Only >> problem, is that that usually requires a caching chip, and another >> daughterboard, making the cost more than $100. >> >> If I'm wrong here, please jump in, I'd LOVE to be able to speed up my ST for >> <$100....(grin) > > The cheapest speed-up board I've seen was a project by the German magazine > "c't" (one of the fall issues, but I can't check it now). It should be around > $100 or cheaper, IF you're prepared to put it together yourself. > As far as I remember, it only speeds up accesses to the ROMs and internal > CPU operations, in RAM it runs at the normal speed (you can't speed up RAM > accesses because the Shifter needs to access video RAM at fixed intervals). > It has no cache, so it isn't as effective as the commercial boards, but it's > CHEAP. > > Jens Kilian > -- Why not just take out the 68000 and put in a 68010, most software should run and should run about 10% faster. People do this to thier amigas,but they have a piece of pd software that gets over some minor incompatability problems. P.S. Its a very cheap upgrade too. Not sure if this will work but it should Andrew Chambers Computer Consultant University Of Waikato New Zealand