Path: utzoo!utgpu!news-server.csri.toronto.edu!bonnie.concordia.ca!thunder.mcrcim.mcgill.edu!snorkelwacker.mit.edu!think.com!samsung!spool2.mu.edu!uunet!tellab5!wiseman
From: wiseman@tellabs.com (Jeff Wiseman)
Newsgroups: comp.sys.mac.hardware
Subject: Re: SCSI ID jumper availability?
Message-ID: <5058@tellab5.tellabs.com>
Date: 14 Jan 91 18:32:47 GMT
References: <3798@orbit.cts.com>
Sender: news@Tellabs.COM
Organization: Tellabs, Inc. Lisle, IL
Lines: 25

In article <3798@orbit.cts.com> pj@pnet51.orb.mn.org (Paul Jacoby) writes:
>With all this talk of SCSI ID's, I just recalled a question that I have not
>found an answer to...
>   Where can I get the little shunts used to set the jumper blocks on my
>Conner 105 meg hard disk?  The pin spacing on the jumper block is incredibly
>small, and is NOT the same size as this pile of jumpers I have from some old 5

I've run into this before. Everytime some takes a stock mac and replaces the
internal drive with a bigger one (usually a quantum 105), they will want to
keep the old drive as an external. However since the internal drive is normally
a low number (0) and since many drives use OPEN jumpers for 0, there is NOTHING
to rearrange to get the higher SCSI address :-)

I have only seen the two different sizes of jumpers. I suspect the dinky ones
that you are talking about are the same as those used in other drives (eg. the
Miniscribes originally installed in the old 20 Meg macs).

Have you tried talking to an Apple Dealer (with the service room in the back :-)
into "selling" you 2 or 3? Usually they have just given them to me since they
usually had them.

Hope this helps

-- 
Jeff Wiseman:	....uunet!tellab5!wiseman OR wiseman@TELLABS.COM