Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!swrinde!zaphod.mps.ohio-state.edu!samsung!xylogics!merk!alliant!linus!linus!basselope.mitre.org
From: dale@basselope.mitre.org (Dale A. Wade)
Newsgroups: comp.sys.zenith.z100
Subject: Disk controller for the z100
Message-ID: <127568@linus.mitre.org>
Date: 4 Jan 91 19:49:30 GMT
Sender: usenet@linus.mitre.org
Organization: The MITRE Corporation, Bedford MA 10730
Lines: 26
Nntp-Posting-Host: basselope.mitre.org



I've got a Heath/Zenith Z-100 which I purchased about 6-7 years ago.  I've
just turned it on after it sat in my basement for 2 years.  Unfortunately
the disk controller board does not pass the power up self test.  The disks
spin up (when it is power cycled with the on off switch--not the reset key), 
the red access LEDs flash briefly, then I get an error indicating the 
controller didn't pass the self test.

After calling (what used to be) my local Heathkit store I found that the Z-100
is no longer supported :-(

Does anybody have a spare controller board that they'd be willing to part
with cheap?  I'm only using the two full height 5 1/4" drives that came
with the system.

Any info would be appreciated.


Thanks,
- Dale
--
+--------------------------------------------------------------------------+
| 		email:	dale@linus.mitre.org                               |
|		voice:	(617) 271-8593                                     |
+--------------------------------------------------------------------------+