Path: utzoo!utgpu!cunews!micor!latour!atronx!rwm
From: rwm@atronx.OCUnix.On.Ca (Russell McOrmond)
Newsgroups: comp.sys.amiga.hardware
Subject: Re: GVP Series II and BridgeBoard Problems?
Message-ID: <57525.664076166@atronx.OCUnix.On.Ca>
Date: Wed Jan 16 19:36:06 1991
Followup-To: comp.sys.amiga.hardware
In-Reply-To: siannce@polyslo.CalPoly.EDU (Twinkie the Sponge Cake)

In a message posted on 15 Jan 91 07:52:11 GMT,
siannce@polyslo.CalPoly.EDU (Twinkie the Sponge Cake) wrote:
TtSC>the hard drive to use it, whenever I started the pcwindows I'd get a requester
TtSC>informing that a library could not be found (Janus didn't tell which library 

it would be the janus.library it is looking for. Are you sure you also installed
the janus.library and janus.library.info into your EXPANSION directory of the
hard disk, and also run the program BINDRIVERS in your startup-sequence?


TtSC>though.) So I whipped out the boot up disk that I used to boot up the bridge 
TtSC>board before the hard-drive and rebooted the amiga. I received the same 

Did you BOOT from this disk, or just use the software from it?   I've not yet
heard anything about Bridgeboard/Series II incompatabilities.  The only
problems I've had with the Series II drives were A500 controllers on
Ancient revision motherboards for the A500.

---
  Opinions expressed in this message are my Own.  My Employer does not even
know what these networks ARE.

  Russell McOrmond   rwm@Atronx.OCUnix.On.Ca   {tigris,alzabo,...}!atronx!rwm 
  FidoNet 1:163/109  Net Support: (613) 230-2282
  Amiga-Fidonet Support  1:1/109