Xref: utzoo comp.unix.xenix.sco:1418 comp.unix.sysv386:4167
Path: utzoo!censor!geac!torsqnt!news-server.csri.toronto.edu!bonnie.concordia.ca!uunet!wuarchive!zaphod.mps.ohio-state.edu!rpi!batcomputer!munnari.oz.au!metro!news
From: dawes@suphys.physics.su.OZ.AU (David Dawes)
Newsgroups: comp.unix.xenix.sco,comp.unix.sysv386
Subject: Re: IDE drive question: Conner vs. Seagate
Message-ID: <1991Jan18.112552.8122@metro.ucc.su.OZ.AU>
Date: 18 Jan 91 11:25:52 GMT
References: <1054@mwtech.UUCP>
Sender: news@metro.ucc.su.OZ.AU
Reply-To: dawes@suphys.physics.su.OZ.AU (David Dawes)
Organization: School of Physics, Uni of Sydney, Australia.
Lines: 39
Nntp-Posting-Host: suphys.physics.su.oz.au

In article <1054@mwtech.UUCP> martin@mwtech.UUCP (Martin Weitzel) writes:
>Due to an error of my distributor I received two IDE drives today. Of
>course, I will return one, but as they are of different brand, I need
>a hint which one to keep. The two are
>
>	- Conner CP320AF (211MB, 16ms)
>	- Seagate ST1239A (210MB, 15ms)
>
>As the specifications are much the same, it may direct my decission
>that the Seagate costs ~15% less, but there are some rumor that the
>Conner is of better quality.
>
>Furthermore I'm a little irritated by some messages concerning OS-fixes
>for IDE drives. (As I were informed by personal mail, there were some
>problems that the drive didn't quite follow the specifications and
>Seagate was explicitely mentioned by one person, but not Conner.)
>
>Finally, in case it should matter: I want to use the drive with SCO
>XENIX/V-386, but it might be that later I move the drive to a system
>running ISC UNIX/386.
>
>Any helpul souls outthere to guide my decission? Thanks in advance.

I have two Conner IDE drives on my system (80MB and 100MB), and I have
found that they work fine with SCO Xenix/V-386 (releases 2.1, 2.3), and
Esix V/386 Rev.D.  My 386 has AT-bus, and the only problem I ever had
was when I increased the bus speed.  I'm not sure if this was because of
the `controller' or the drive electronics.

BTW, does anyone have any information regarding the logical
head/cylinder/sectors configuration of the various Conner IDE drives?
Since I didn't get any docs with the drives, I had to use trial-and-error.

David
--
------------------------------------------------------------------------------
 David Dawes (dawes@suphys.physics.su.oz.au) DoD#210   | Phone: +612 692 2639
 School of Physics, University of Sydney, Australia    | Fax:   +612 660 2903
------------------------------------------------------------------------------