Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!sdd.hp.com!hp-pcd!hpfcso!steve-t
From: steve-t@hpfcso.HP.COM (Steve Taylor)
Newsgroups: comp.sys.hp
Subject: Re: Kermit Problems
Message-ID: <7370291@hpfcso.HP.COM>
Date: 28 Jan 91 23:09:18 GMT
References: <1991Jan28.122231.95@drycas.club.cc.cmu.edu>
Organization: Hewlett-Packard, Fort Collins, CO, USA
Lines: 19

// morro@drycas.club.cc.cmu.edu // asks:
|	I am trying to set up Kermit on our HP 9000 series 200/300 computers
| but I'm running into few problems.  Our HPs are running HP Basic and are

I don't know anything about the Kermit connection problems, so I've left
that part out.

|	An additional side effect of Kermit is that it seems to set the
| HP terminal so that it does not issue LF characters so after using Kermit
| when I do CAT the output looks garbled.  I haven't found a way to fix that
| other than by doing cold reboot.

Sounds like Kermit is setting the EOL sequence for the CRT "printer" device.
Try doing:  PRINTER IS CRT  after exiting from Kermit to reset the default
values.  If this doesn't work, SCRATCH A _should_ fix it.  Hope this helps.

						Regards, Steve taylor

NOT A STATEMENT, OFFICIAL OR OTHERWISE, OF THE HEWLETT-PACKARD COMPANY.