Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!sdd.hp.com!zaphod.mps.ohio-state.edu!caen!umich!sharkey!nstar!rocco From: rocco@nstar.rn.com (Rocco Calderone) Newsgroups: comp.sys.zenith Subject: Re: Jumper settings for disk controller Message-ID: Date: 23 Jan 91 23:47:12 GMT References: <9}7^NG=@rpi.edu> Sender: bbs@nstar.rn.com (BBS Account) Organization: NSTAR Public Access BBS 219-289-0282 Lines: 16 If you want to install an additional HD, the problem is not with the HD controller. 1. Ribbon cable must allow you to connect 2 HD's 2. the junkpers on the HD's must both be set to the second drive. i.e. if pin # 1 & 2 are jumped for disk 1, then pins 2 & 3 must be jumped on both drives. 3. You must set up the correct HD type press Alt/Ctl and Ins key and type in: setup That should do it for you........ -- internet: rocco@nstar.rn.com internet: rocco%nstar@iuvax.cs.indiana.edu uucp: ..!uunet!nstar.rn.com!rocco Northern Star Communications, Notre Dame, IN USA Public Access Unix Site - 219-289-0282