Path: utzoo!utgpu!news-server.csri.toronto.edu!bonnie.concordia.ca!thunder.mcrcim.mcgill.edu!snorkelwacker.mit.edu!apple!agate!ucbvax!ucsd!sdcc6!sdcc13!gbell From: gbell@sdcc13.ucsd.edu (Last First) Newsgroups: sci.electronics Subject: Re: pcb construction Keywords: pcb, protoyping, HTE Corp. Message-ID: <15901@sdcc6.ucsd.edu> Date: 23 Jan 91 05:58:34 GMT References: Sender: news@sdcc6.ucsd.edu Organization: University of California, San Diego Lines: 50 Nntp-Posting-Host: sdcc13.ucsd.edu In article scafidi@aramis.rutgers.edu (John Scafidi) writes: > > >Recently I got some information in the mail from HTE Corporation in >San Diego. They sell a pcb prototyping system that enables you to make >single, double and multilayer printed circuit boards. It consists >mainly of a plotter that draws the traces on the pcb with an etch >resistant ink. The plotter also has a drilling attachment to drill the >holes and vias. The system also includes a tank for the sodium >persulphate etchant. > >The boards it produces are not plated thru holes. So soldering must be >done on each side of the board. How reliable and how inconvenient is >this? > >Multilayer boards are made by first making a double sided board and >then making layers on flexible laminates and then soldering the layers >to one side of the double sided board. > >John Scafidi >Integrated Systems Lab >Rutgers University >(908) 932- 5172 Well, I used to work for HTE, so you might consider my opinion biased, but then again, I have experience with the system. The guys at HTE have made tons of boards with the system, and I have made a few myself. The lack of plated thru holes is not that much of a hassle - many people who can't afford plated holes for their project or prototype do without. First, you need a sharp soldering iron tip, so you can get around the components on the top side. And, when I'm designing a double sided board with no plated holes, I make an additional hole just out from the IC pin that must be soldered on both sides. Then, instead of melting your IC socket, you just make the connection to the other side by soldering a wire in the hole on both sides. Make sense? The multi layer boards are a different story. I've seen a bunch already made, and they use the flex circuit material for other things, but I can't personally comment on it. Again, they do it in-house a lot, so I'd say you have a good chance of being able to duplicate the feat. Since they use the thing themselves for in house projects, I would think its a reasonable product! Greg Bell gbell@sdcc13.ucsd.edu