Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!swrinde!elroy.jpl.nasa.gov!sdd.hp.com!zaphod.mps.ohio-state.edu!know!tegra!vail
From: vail@tegra.COM (Johnathan Vail)
Newsgroups: comp.periphs.scsi
Subject: Re: MFM to SCSI?
Message-ID: <2019@atlas.tegra.COM>
Date: 4 Feb 91 15:34:23 GMT
References: <``#&X~$@rpi.edu>
Organization: Tegra-Varityper, Inc., Billerica, MA
Lines: 24
In-reply-to: woody@iear.arts.rpi.edu's message of 31 Jan 91 22:56:00 GMT


In article <``#&X~$@rpi.edu> woody@iear.arts.rpi.edu (Christopher Widmann) writes:

   I have just aquired a dead Dataframe 20 meg SCSI box for a Macintosh.
   The drive is dead, but it is a MFM drive and has an SMS OMTI 3100 SCSI
   to MFM converter card mounted in the box. I was wondering if anyone
   happens to have any of the jumper settings for drive sizes and scsi id
   required by this card. I would like to use it with a 40 meg or 2 20 meg
   drives, and need the jumper settings so that I can set it up. Thanks.

   -----------------------------------------------------------------------------

I am not familiar with the 3100 but if it is similar to the 3500 then
all the setup is done through the mode-select command and not through
jumpers.

jv

"Frisbeetarianism is the belief that when you die, your soul goes up on
the roof and gets stuck." -- button
 _____
|     | Johnathan Vail | n1dxg@tegra.com
|Tegra| (508) 663-7435 | N1DXG@448.625-(WorldNet)
 -----  jv@n1dxg.ampr.org {...sun!sunne ..uunet}!tegra!vail