Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!swrinde!zaphod.mps.ohio-state.edu!samsung!umich!umeecs!msi.umn.edu!cs.umn.edu!sialis!orbit!pnet51!amadeus
From: amadeus@pnet51.orb.mn.org (Christoper Helget)
Newsgroups: comp.sys.mac.misc
Subject: No submenu's (hierDA) and MacsBug problems
Message-ID: <4010@orbit.cts.com>
Date: 5 Feb 91 09:45:23 GMT
Sender: news@orbit.cts.com
Organization: People-Net [pnet51], Minneapolis, MN.
Lines: 21

Two Software Questions:
1.  Just having upgraded to a IIcx I've installed a fresh copy of System
6.0.7, but the "hierarchical menus" do not work.  In other words, in programs
which are to have submenus, only the arrow appears.  I've tried using "hierDA"
which adds submenus to DA's and the control panel but this doesn't work
either.  HierDA loads but only the arrows appear with no submenu.  Can I use
ResEdit to fix this?  (note that these same system disks worked fine with an
SE/30).
 
2.  What version of MacsBug should I be using with a IIcx and System 6.0.7?  I
used version 6.1 on an SE/30 without a hitch.  When I press the interrupt
button on the programmers switch of the IIcx I get a grey screen with no
debugging window.  I have to press reset to escape and reboot.  Could my
RasterOps video card (with Apple's RGB) be causing the problem?

I would appreciate any suggestions or solutions!
Email to: amadeus@pnet51.orb.mn.org

UUCP: {amdahl!bungia, uunet!rosevax, crash}!orbit!pnet51!amadeus
ARPA: crash!orbit!pnet51!amadeus@nosc.mil
INET: amadeus@pnet51.orb.mn.org