Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!usc!pollux.usc.edu!papa From: papa@pollux.usc.edu (Marco Papa) Newsgroups: comp.sys.amiga.datacomm Subject: Re: 19200 baud amiga Message-ID: <30257@usc> Date: 13 Feb 91 07:34:30 GMT References: <2587@tmiuv0.uucp> Sender: news@usc Organization: Felsina Software, Los Angeles, CA Lines: 28 Nntp-Posting-Host: pollux.usc.edu In article sbeagle@kennels.actrix.gen.nz (Sleeping Beagle) writes: >rick@tmiuv0.uucp writes: >> In article , cshort@nmsu.edu (Spmg*d, Lor || | i've got my amiga 1000 at work wired (pins 2,3,7) to a sparc station. || | the setup works great at 9600 baud, but i would really like to run || | things at 19,200 (i'm greedy, eh). here's the problem: || | || | when i cat a large file i get overflow errors & || | when i try to d/u load i get bad CRC's. i'm using Atalk III and || | unix based send zmodem (sz 3.07) Make sure that you're using RTS/CTS handshake at those speeds (make sure that the sparc serial port is set up that way, too). |This is with half duplex enabled (if that does anything in this mode!) This doesn't doe ANYTHING at all. |and XON/XOFF handshaking enabled. This one also has no efect on Zmosdem since Zmodem throws away Xon/Xoffs. Zmodem is built to work best with RTS/CTS enabled. -- Marco -- -=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-= "Xerox sues somebody for copying?" -- David Letterman -=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=