Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!wuarchive!usc!jarthur!ucivax!orion.oac.uci.edu!ucsd!chiton!cdl From: cdl@chiton.ucsd.edu (Carl Lowenstein) Newsgroups: comp.sys.next Subject: Re: Fujitsu installation problems... Message-ID: <711@chiton.ucsd.edu> Date: 15 Feb 91 22:20:45 GMT References: <26929@uflorida.cis.ufl.EDU> Reply-To: cdl@chiton (Carl Lowenstein) Organization: MPL of SIO at UCSD Lines: 22 In article ice@wang.com (Fredrik Nyman) writes: |mfi@serc.cis.ufl.edu (Mark Interrante) writes: |> The drive sits on top of the OD with the power cable on the right. |> When I plug the 25 pin flat cable (that comes out of the cpu |> to the OD then to the HD) in and boot the cube says loading from OD |> then immediatley tries to load off the network (which doent exist). |It sounds like your OD has a SCSI bus termination. Remove it and make |sure your Fujitsu has SCSI termination. The OD is not a SCSI device, and has its own bus and cables. Somewhere there has to be another cable for the SCSI. Also, a SCSI cable is 50 pins wide, not 25. So look for the 50-pin connector on the mother board, and try to follow it along toward the drive bay. Maybe you will have to get another cable, if there isn't one already present. It's a straight 50-pin to 50-pin flat cable, pin 1 to pin 1 etc. -- carl lowenstein marine physical lab u.c. san diego {decvax|ucbvax} !ucsd!mpl!cdl cdl@mpl.ucsd.edu clowenstein@ucsd.edu