Xref: utzoo comp.unix.sysv386:5011 comp.protocols.tcp-ip:14945 comp.protocols.tcp-ip.ibmpc:4923 Path: utzoo!utgpu!watserv1!watmath!att!emory!swrinde!cs.utexas.edu!rutgers!rochester!kodak!gizzmo!mark From: mark@gizzmo.UUCP (mark hilliard) Newsgroups: comp.unix.sysv386,comp.protocols.tcp-ip,comp.protocols.tcp-ip.ibmpc Subject: Re: TCP/IP under SCO UNIX with CUTCP/NCSA Message-ID: <4@gizzmo.UUCP> Date: 15 Feb 91 02:58:41 GMT References: <23171@well.sf.ca.us> Reply-To: mark@gizzmo.UUCP (mark hilliard) Followup-To: comp.unix.sysv386 Organization: gizzmo Lines: 31 You said that you entered the ethernet address that was listed on the back of the card. I just installed 2 ODT systems using the WD8003 also, and nowhere did I enter the ethernet address, instead I entered a IP address ie: 129.126.55.28 which was automatically put into a file called /etc/tcp, which starts up tcp/ip on boot up. You also need to enter your IP address in /etc/hosts as well as those for the systems that you wish to reach ie: 127.0.0.1 localhost local 129.126.55.28 brandon <-------------------local system 129.126.12.158 brandy When the system comes up then you should be able to ping the remote system. If this information is not there or incorrect (ie: your IP address does not match your machine name), you can still ping localhost and yourself, but you will not get out onto the wire. You also mentioned that you just ran thinwire ethernet (RG-58 50 ohm cable with BNC connectors) between your 2 machines, did you put a terminator at each end? If not your WILL have problems. Forgive me if this has already been done on your system. I am NOT an ethernet expert, but I have put together about 20 systems of various types and connected them with TCP and NFS and struggled through the configuration and setup. -- ++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++ | Mark Hilliard, N2HHR | AWK is not just a | | Fax 315-986-5882 | LANGUAGE | | mark@gizzmo.kodak.com | It is a way of LIFE! |