Path: utzoo!mnetor!tmsoft!torsqnt!news-server.csri.toronto.edu!bonnie.concordia.ca!uunet!midway!ellis.uchicago.edu!lair From: lair@ellis.uchicago.edu (scott allen laird) Newsgroups: comp.sys.ibm.pc.hardware Subject: Re: Conner IDE drive on 486? Message-ID: <1991Feb17.050052.19913@midway.uchicago.edu> Date: 17 Feb 91 05:00:52 GMT References: Sender: news@midway.uchicago.edu (News Administrator) Distribution: comp Organization: University of Chicago Lines: 34 In article olender@cs.colostate.edu (Kurt Olender) writes: > >An earlier posting mentioned a possible incompatibility between Conner >IDE 100MB drive and 486 OPTI chipset motherboards. I've had such problems >but in checking it out discovered exactly the same problem with a totally >different motherboard. So perhaps its not the motherboard after all. > >Has anyone out there successfully used a Conner CP-344 104 MB drive on >a 486 without any problems. Has anyone else had problems? I'm not sure, but the problem could have something to do with the fact that your 100Mb CP-344 is only a 40Mb hard drive according to the instructions that came with my Connor. Maybe that could be the problem, you have it set for the wrong size in your setup program. CP-344 ------ Heads: 4 Cylinders: 805 Sectors/Track: 26 Size: 40 Mb I hope this helps... Source: HDI's "Installation Sheet" for Connor Drives. The only relationship I have with them is that of a satisfied customer. -- Scott A. Laird | Any semblance of the above to anything is purely lair@midway.uchicago.edu | coincidental, as it was the result of an infinite The University of Chicago | number of monkeys sneaking in to use my computer | for the afternoon.