Xref: utzoo sci.electronics:17865 rec.audio:28991 Path: utzoo!utgpu!news-server.csri.toronto.edu!bonnie.concordia.ca!nstn.ns.ca!news.cs.indiana.edu!att!linac!uwm.edu!ux1.cso.uiuc.edu!phil From: phil@ux1.cso.uiuc.edu (Phil Howard KA9WGN) Newsgroups: sci.electronics,rec.audio Subject: converting AUX level to MIC level Keywords: aux mic level Message-ID: <1991Feb19.220209.13013@ux1.cso.uiuc.edu> Date: 19 Feb 91 22:02:09 GMT Organization: University of Illinois at Urbana Lines: 22 I am wanting to connect a tape recorder that has only MIC input to a device that has AUX or earphone or speaker level outputs. What I need is some level of attenuation. I have not worked with these before so I don't know what the typical levels and impedances are. Does anyone know this and/or have good working circuits for apply the proper attenuation? Are there any other things that need to be done besides just attenuation? The recorder I have is a Sony TCM-38V. The instructions recommend using special connector cords for recording from various sources. For dubbing between 2 cassette units they recommend model RK-G64. The same is also recommended for recording from a radio or TV equipped with an earphone jack. The RK-G69 is recommended for recoding from a radio or TV equipped with a recording jack. I suspect what I need to do is reproduce these cords unless some wonderful dealer happens to stock these possibly rare items. (Maybe RS? Nah!) Email: phil-howard@uiuc.edu or ka9wgn@uiuc.edu Thanks. -- --Phil Howard, KA9WGN-- | Individual CHOICE is fundamental to a free society | no matter what the particular issue is all about.