Xref: utzoo trial.rec.metalworking:64 misc.misc:11272
Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!swrinde!zaphod.mps.ohio-state.edu!rpi!uwm.edu!uwvax!rennet.cs.wisc.edu!stuart
From: stuart@rennet.cs.wisc.edu (Stuart Friedberg)
Newsgroups: trial.rec.metalworking,misc.misc
Subject: Re: Toolbit Grinding Jigs?
Message-ID: <1991Feb19.004819.22087@spool.cs.wisc.edu>
Date: 19 Feb 91 00:48:19 GMT
References: <5580@bwdls58.UUCP> <5584@bwdls58.UUCP> <7598@crash.cts.com>
Sender: news@spool.cs.wisc.edu (The News)
Distribution: na
Organization: U of Wisconsin CS Dept
Lines: 15

In article <7598@crash.cts.com> danr@crash.cts.com (Dan Rubesh) writes:
>Most tooling used in the modern machine shop environment are of the
>indexable carbide insert variety.. I'm not aware of any specific jigs
>for grinding HSS lathe tools,

Glendo's Grinder Table is a simple, very sturdy, tool rest with miter
that can be set for compound angles.  I recently purchased their
2-in-1 combination package:  a Baldor 712 grinder, a Darex M3 drill
grinding fixture, a Grinder Table, and a steel plate and adapters for
quick mounting of the M3 and GT.  I've only used it for about 1 1/2
hours, so far, but I've been quite satisfied.

Glendo's phones, addresses, and ads can be found in Home Shop Machinist.

Stu Friedberg (stuart@cs.wisc.edu)