Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!wuarchive!rex!uflorida!gatech!ncar!zaphod.mps.ohio-state.edu!unix.cis.pitt.edu!pitt!willett!ForthNet
From: ForthNet@willett.pgh.pa.us (ForthNet articles from GEnie)
Newsgroups: comp.lang.forth
Subject: LMI Forth(s)
Message-ID: <2401.UUL1.3#5129@willett.pgh.pa.us>
Date: 21 Feb 91 23:30:44 GMT
Organization: (n.) to be organized.  But that's not important right now.
Lines: 26


 Date: 02-19-91 (14:15)              Number: 1250 of 1262 (Echo)
   To: RAY DUNCAN                    Refer#: NONE
 From: CHARLES WILSON                  Read: 02-19-91 (14:39)
 Subj: UR/FORTH ->WINDOWS?           Status: PUBLIC MESSAGE
 Conf: FORTH (58)                 Read Type: GENERAL (+)

 Any chance that a preliminary version of UR/FORTH for Windows 3.0 will
 be available in the near future?  Getting ready for the Mother of all
 software conversions, and was hoping to be able to use some familiar
 tools.  I am hooked on interactive development, and would hate to have
 to go back to compile, link, etc.

 I like the editor. I probably should start using ANSI.SYS, or some other
 terminal emulation mode.  Right now using st-240 with DEC terminal
 emulation set to VT-100.
 ---
  * Via ProDoor 3.1R

 NET/Mail : LMI Forth Board, Los Angeles, CA (213) 306-3530
 <<<>>>
-----
This message came from GEnie via willett.  You *cannot* reply to the author
using e-mail.  Please post a follow-up article, or use any instructions
the author may have included (USMail addresses, telephone #, etc.).
Report problems to: dwp@willett.pgh.pa.us _or_ uunet!willett!dwp