Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!samsung!dali.cs.montana.edu!rpi!uupsi!sunic!news.funet.fi!funic!santra!nntp!ebu From: ebu@vipunen.hut.fi (Erik Bunn) Newsgroups: comp.sys.ibm.pc.hardware Subject: WD hard drive controller - need jumper settings Message-ID: Date: 23 Feb 91 12:08:13 GMT Sender: news@santra.uucp (Cnews - USENET news system) Distribution: comp.sys.ibm.hardware Organization: Helsinki University of Technology, Finland Lines: 30 (I'm having problems posting, sorry if this is repeated.) I recently acquired a used Western Digital HD controller. The sticker states the model as WD1002S-BIC followed by a set of numbers. Does this seem familiar to any of you? If you have the manual for one, please reply and tell me the jumper settings. (Basically, there are two sets of switches: sw6 with pins 1-3, and a battery of 9 two-pin switches.) thanks; ebu -- Erik Bunn I f36608s@puukko.hut.fi (Internet) I "You see, I missed her ebunn@otax.hut.fi I terribly..." ebu@blake.acs.washington.edu I ebu@t386.hut.fi I "Next time, aim between ----------------------------------------I the eyes." (90) 455-1041 (HPY-net) I (971) 227-493 occasionally I