Path: utzoo!utgpu!news-server.csri.toronto.edu!rutgers!ucsd!sdd.hp.com!news.cs.indiana.edu!arizona.edu!uazhe0.physics.arizona.edu!zazula From: zazula@uazhe0.physics.arizona.edu (RALPH ZAZULA) Newsgroups: comp.sys.next Subject: HELP needed getting MICROPOLIS 1578 working in cube Message-ID: <25FEB91205038@uazhe0.physics.arizona.edu> Date: 26 Feb 91 04:50:38 GMT Reply-To: zazula@uazhe0.physics.arizona.edu Distribution: usa,local Organization: University of Arizona Physics Department Lines: 29 Nntp-Posting-Host: uazhe0.physics.arizona.edu News-Software: VAX/VMS VNEWS 1.3-4 Lines: 29 HELP!!! I just got my BLand Cube today (OD only) and I'm trying to get this Micropolis 1578 drive that has been sitting on my shelf for two weeks installed in it. When I first booted the Cube, it gave me a "system test failed" message. I went into the ROM monitor and saw "error 65". My campus rep. said that that was an error generated by the SCSI test.... I was able to boot with "bod" and when I looked at preferences, I saw that the boot device was a hard disk (which wasn't there). I changed it to OD. If I run the SCSI tests, I still get error 65. The 1578 didn't come with any explicit instructions. I just plugged in the power, a 50-pin cable and powered up. A "scsimodes /dev/rsd0a" turned up nothing. Are there some jumper settings that I'm missing (like SCSI address)? Please help - this OD is *slow*.... Thanks, Ralph |----------------------------------------------------------------------| | Ralph Zazula "Computer Addict!" | | University of Arizona --- Department of Physics | | UAZHEP::ZAZULA (DecNet/HEPNet) | | zazula@uazhe0.physics.arizona.edu (Internet) | |----------------------------------------------------------------------| | "You can twist perceptions, reality won't budge." - Neil Peart | |----------------------------------------------------------------------| Brought to you by Super Global Mega Corp .com