Path: utzoo!utgpu!news-server.csri.toronto.edu!rutgers!cbmvax!uunet!contex!dan
From: dan@contex.UUCP (Daniel Easley)
Newsgroups: comp.sys.ibm.pc.hardware
Subject: Adding a Conner drive
Keywords: Conner, IDE
Message-ID: <1676@contex.UUCP>
Date: 28 Feb 91 21:08:12 GMT
Distribution: usa
Organization: Xyvision Design Systems, Wakefield MA
Lines: 34



	I am trying to add a second hard disk to my Compaq 286e.  I already
have a 40M Conner and want to add a 100M Conner.  I have tried a few 
combinations, but without any luck.  If I connect only 1 drive (either) it
works fine.  I just can't get the setup to find the second drive.  This is
what I am trying now:

 ================================================================
 ================================================================
 ================================================================
 ================================================================
 ================================================================
 ^			^					^
 ^			^					^
 Motherboard            100M					40M

			HSP -  					HSP -  
			C/D -  					C/D - X
			DSP -  					DSP -  
			ACT - X					ACT - X

The X denotes a jumper.

	Are the jumpers correct?  Is there some switch on the motherboard that
I must set?  Any pointers will be greeeeeeeaaaaaatly appreciated.



---------------------------
   Daniel Easley					Xyvision Design Systems
   contex!dan@uunet.uu.net            		    	WORK : 617-224-5573
   uunet!contex!dan
---------------------------