Path: utzoo!utgpu!news-server.csri.toronto.edu!rutgers!ub!res
From: res@sybil.cs.Buffalo.EDU (Robert Szczesniak)
Newsgroups: comp.sys.ibm.pc.hardware
Subject: WD 1002A controller
Message-ID: <62696@eerie.acsu.Buffalo.EDU>
Date: 1 Mar 91 17:08:43 GMT
Sender: news@acsu.Buffalo.EDU
Distribution: usa
Organization: State University of New York at Buffalo/Comp Sci
Lines: 18
Nntp-Posting-Host: sybil.cs.buffalo.edu
Originator: res@sybil.cs.Buffalo.EDU

I have a WD 1002a controller (RLL) and I am trying to connect it to 
a Seagate 157R drive.  I originally had a Seagate 238R connected and
it worked fine.  When I connected the jumpers and the power cable and
turned on my computer, it booted fine from the A: drive, but drive
C: was not recognized, hense I couldn't format it.
The rom on the card is used and the motherboard rom is disabled.  I 
configured the drive as drive select 1 and the cables went from J1, J2
on the card to J1, J2 on the drive respectively.  

I don't have the manual for the card and was wondering if anybody
could offer suggestions on improving my configuration.

Robb Szczesniak

-- 
----
Robert Szczesniak, State Univ. of New York at Buffalo
res@cs.buffalo.edu  |  res%cs.buffalo.edu@ubvm.bitnet