Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!helios!mtecv2!al158305 From: al158305@mtecv2.mty.itesm.mx (Gustavo Cordova Avila) Newsgroups: comp.sys.amiga.misc Subject: Re: Hhhhhelllllpppp !!!!!!!!!!!! Keywords: Help! Message-ID: <3026@mtecv2.mty.itesm.mx> Date: 7 Mar 91 04:36:59 GMT References: Organization: ITESM. Campus Monterrey Lines: 26 mac1@ra.MsState.Edu (Dude) writes: > Somebody recently told me that it is not possible to run PAL programs on an >NTSC machine that I'm using right now. I have tons of software in UK and my >parents are about to send it to me. I'm worried to death !! Can somebody tell >me if the guy is right or wrong ? I'll relly appreciate any help in this >regard. If thats true then is ther any simple or complicated solution to this >problem. Hell alot of thanks in advance. Mob They guy was right, only that you *need* to have in your machine the new agnus chip. If you *do* have in installed, then you only need to run a little program like BPD ("Boot PAL Dammit!") or BootMenu which will install a little wedge on bootup that'll change a little bit in the agnus chip to change from ntsc to pal. You can FTP these progs from NewXanth (I can't remember the numeric address right now, but the sites name it ab20.larc.nasa.gov). If you don't have access to ftp email me and I'll get send them to you. Good luck!! Gustavo Cordova -- | From Mexico! Majoring in Electronics Systems Engineering, | | ITESM presents to you: Gustavo Cordova Avila!!! | | And then I woke up :) +------------------------------------+ +-----------------------+