Path: utzoo!news-server.csri.toronto.edu!cs.utexas.edu!uwm.edu!zaphod.mps.ohio-state.edu!tut.cis.ohio-state.edu!VAX1.CC.UAKRON.EDU!mcs.kent.edu!usenet.ins.cwru.edu!ncoast!nshore!railnet!michael
From: michael@railnet.nshore.ncoast.ORG (Michael Mitchell)
Newsgroups: comp.unix.xenix.sco
Subject: SCO cu flow control
Message-ID: <7Bqey2w163w@railnet.nshore.ncoast.ORG>
Date: 6 Mar 91 21:46:29 GMT
Distribution: na
Organization: Railnet BBS +1 216 883 6298
Lines: 11

I am trying to set up dial-in/dial-out capability on SCO
Xenix 386 2.3.2 with an error-correcting modem (Multi-tech
2400EH).  Ideally, I would like to use RTS/CTS flow control.
Dialing into the Xenix box works fine ... good flow control,
stty shows the expected rtsflow & ctsflow.  The problem is
the dial-out side with cu.  The flow control isn't active.
I would appreciate any ideas to correct this problem.

Michael V. Mitchell
al232@cleveland.Freenet.Edu
michael@railnet.nshore.ncoast.org