Xref: utzoo comp.sys.ibm.pc.hardware:6361 comp.sys.ibm.pc.misc:7320 Path: utzoo!news-server.csri.toronto.edu!rutgers!elbereth.rutgers.edu!roy From: roy@elbereth.rutgers.edu (Herbert Roy) Newsgroups: comp.sys.ibm.pc.hardware,comp.sys.ibm.pc.misc Subject: Problem with Bernoulli Box Application Program Keywords: IBM PC/AT, Bernoulli Box, Real World Software Message-ID: Date: 11 Mar 91 12:15:39 GMT Followup-To: comp.sys.ibm.pc.hardware Distribution: na Organization: Rutgers Univ., New Brunswick, N.J. Lines: 30 Hello, I am attempting to run an inventory control program sold by the Real World Company on a Bernoulli Box attached to an IBM PC/AT. Unfortunately, I occasionally get a "SETBLOCK FAILED" error message when I run this program or the program crashes. I contacted the customer service department at Real World and IOMEGA (the manufacturers of the Bernoulli Box) and was told that the "SETBLOCK FAILED" error message does not come from their software and/or hardware. I ran the IOMEGA diagnostic program (version 6.21) which showed the status of the adapter board and add-on driver to be OK--there were "ERRORS" for the boot ROM (this is not surprising since I did not format the 20 Mb Bernoulli cartridge to be bootable). Any suggestions or comments on this problem would be appreciated. Since I do not get to read this newsgroup that often, please reply to either roy@elbereth.rutgers.edu or HROY@Zodiac.rutgers.edu If there is sufficient interest, I'll post a summary of the responses. From, Herbert Roy Center of Alcohol Studies Rutgers University New Brunswick, NJ