Path: utzoo!utgpu!news-server.csri.toronto.edu!rpi!zaphod.mps.ohio-state.edu!tut.cis.ohio-state.edu!ucbvax!bloom-beacon!eru!hagbard!sunic!cs.umu.se!dvljrt
From: dvljrt@cs.umu.se (Joakim Rosqvist)
Newsgroups: comp.sys.amiga.programmer
Subject: Re: Hardware-POKEr wants to write systemfriendly code!
Message-ID: <1991Mar23.143523.13079@cs.umu.se>
Date: 23 Mar 91 14:35:23 GMT
References: <1991Mar23.142053.12955@cs.umu.se>
Sender: news@cs.umu.se (News Administrator)
Organization: Dep. of Info.Proc, Umea Univ., Sweden
Lines: 41

In article <1991Mar23.142053.12955@cs.umu.se> dvljrt@cs.umu.se (Joakim Rosqvist) writes:
>Can someone tell me how to do these things in a system-friendly way:
>
>1. A program that starts from the CLI and exits when you press a certain
>   key. The character is not supposed to be echoed to the screen, and I
>   do not want to open another window.
>2. The same thing as 1, but with a raw key-code instead of an ASCII-code.
>3. Is there a way to make the system forget there was ever a mouse?
>   that is, don't care if a press a button or move the mouse, but still
>   run multitasking and validate disks etc.
>4. How to switch disk-validation off, so you could make a program that
>   would format a disk without it being validated.
>5. How to find the Output-handler to the active CLI-window. The program
>   that wants it is started from an interrupt and not from the CLI, so
>   I cant just call OUTPUT()
>6. The system checks for new disks about every 2.5 seconds. could this be
>   changed?
>7. If i type "path" at the CLI-prompt i get something like:
>
><current directory>
>C:
>
>How can this be changed to:
>
><current directory>
>df0:c
>C:
>
>I tried "path df0:c" but that results in
>
><current directory>
>NameOfMyDisk:c
>C:
>
>I want to specify the drive rather than the disk!
>Does this need a special program?
>
>Thanks for any help / $DR.HEX$
>

Solutions in ASSEMBLER of course! /$DR.HEX$