Path: utzoo!utgpu!news-server.csri.toronto.edu!rpi!zaphod.mps.ohio-state.edu!swrinde!elroy.jpl.nasa.gov!jato!hanauma.jpl.nasa.gov!hyc From: hyc@hanauma.jpl.nasa.gov (Howard Chu) Newsgroups: comp.sys.atari.st Subject: Re: Character sets? Keywords: CHARACTER SETS, CHAR SET EDITORS, CHAR SET LOADERS Message-ID: <1991Mar29.235920.9562@jato.jpl.nasa.gov> Date: 29 Mar 91 23:59:20 GMT References: <4qukZ1w162w@fquest.fidonet.org> Sender: news@jato.jpl.nasa.gov Organization: SAR Systems Development and Processing, JPL Lines: 21 Nntp-Posting-Host: hanauma.jpl.nasa.gov In article chuck@mrcnext.uiuc.edu (charles bridgeland) writes: >mspacek@fquest.fidonet.org (Mark Spacek) writes: >> I got to thinking about installing an ANSI character set to make a >>VT-100 terminal work better with a PC ANSI BBS, etc. So, I'd kinda like >>to get some feedback about what character set editors are out there. >>And do you need a utility to install them, or is it possible to make a If you're a moderately competent programmer you can do this easily enough. You can link the font data in with your program, which is what this MACINTOS program you were talking about does. > along the same line--is there any fast, easy, prepackaged way to get >Uniterm to use a more standard character set? What do you mean by "more standard" ? Uniterm 2.0 does a full vt220 emulation; uses the standard vt series character set, and also comes with the ISO 2022 character set. You can't get more standard than that. If that's not a good enough answer for you, then redefine the question... -- -- Howard Chu @ Jet Propulsion Laboratory, Pasadena, CA Disclaimer: How would I know, I just got here!