Path: utzoo!utgpu!news-server.csri.toronto.edu!rpi!usc!apple!agate!pasteur!nima.berkeley.edu!splin
From: splin@nima.berkeley.edu (Steven Lin)
Newsgroups: comp.windows.ms
Subject: QEMM 5.11 and Standard Mode
Message-ID: <12370@pasteur.Berkeley.EDU>
Date: 2 Apr 91 03:37:13 GMT
Sender: news@pasteur.Berkeley.EDU
Reply-To: splin@nima.berkeley.edu (Steven Lin)
Distribution: na
Organization: U.C. Berkeley -- ERL
Lines: 33

Can anybody help me on this one?  Windows 3.00a refuses to start up in standard
mode with qemm installed; the opening screen comes up but immediately
exits to DOS.  It will start up in real and enhanced modes. 
I used the following config.sys and autoexec.bat files:

device=c:\qemm\qemm386.sys ram rom
files=30
buffers=20

\dos\share
path c:\windows;c:\dos;c:\
set TEMP=c:\windows\temp

I tried adding x=b000-b7ff, but it didn't help.  If I remove qemm and
replace it with himem.sys, then all three modes work.

My system configuration is:

	Micronics 386-16 with 6Mb
	Orchid Prodesigner w/512k (not the Prodesigner II)
	Sony 1304 Multi-Scan VGA Monitor
	80Mb Conner IDE Hard Drive
	MicroSoft Serial Mouse (com1)
	Modem (com2)
	Sound Blaster sound card
	MS-DOS 4.01

Now for a different problem.  Sometimes Windows 3.0 refuses to start up
in real mode under Desqview 2.31.  It says something like, "Incorrect Dos 
version.  Dos 3.1 or greater required."  I'm running MS-DOS 4.01, so the error 
message doesn't make sense.  This problem seems to only occur when two or three 
Desqview windows are already open.  It always starts whenever I open it first, 
before anything else.