Path: utzoo!utgpu!news-server.csri.toronto.edu!rpi!zaphod.mps.ohio-state.edu!uakari.primate.wisc.edu!umriscc!mcs213k.cs.umr.edu!robf
From: robf@mcs213k.cs.umr.edu (Rob Fugina)
Newsgroups: sci.electronics
Subject: Re: PAL/GAL/EPLD's
Message-ID: <2521@umriscc.isc.umr.edu>
Date: 28 Mar 91 17:15:45 GMT
References: <2492@umriscc.isc.umr.edu> <39VHZ1w163w@k5qwb.UUCP>
Sender: news@umriscc.isc.umr.edu
Organization: University of Missouri - Rolla
Lines: 13

In article <39VHZ1w163w@k5qwb.UUCP> lrk@k5qwb.UUCP (Lyn R. Kennedy) writes:
>robf@mcs213j.cs.umr.edu (Rob Fugina) writes:
>If I understood your posting right (8 bit binary to BCD) you can do
>it with any EPROM with 8 or more address bits and 8 data bits. Get
>your local hobbyist to program the BCD codes at the proper addresses
>and connect the upper address bits to ground.
>Lyn Kennedy      K5QWB @ N5LDD.#NTX.TX.US

I'm not the one that wanted to know that...I just want to learn more about
the programmable logic stuff...right now, I need to get ahold of some
software...

Rob  robf@cs.umr.edu