Newsgroups: comp.protocols.tcp-ip.ibmpc
Path: utzoo!utgpu!news-server.csri.toronto.edu!rpi!clarkson!grape.ecs.clarkson.edu!nelson
From: nelson@sun.soe.clarkson.edu (Russ Nelson)
Subject: Re: Trying to get WD8003E driver working...
Reply-To: nelson@clutx.clarkson.edu (aka NELSON@CLUTX.BITNET)
Organization: Clarkson University, Potsdam NY
Distribution: usa
Date: 9 Apr 91 22:54:36
Message-ID: <NELSON.91Apr9225436@sun.clarkson.edu>
In-Reply-To: jstern@orion.oac.uci.edu's message of 6 Apr 91 02:20:44 GMT
References: <27FD307C.11763@orion.oac.uci.edu>
Sender: usenet@grape.ecs.clarkson.edu

In article <27FD307C.11763@orion.oac.uci.edu> jstern@orion.oac.uci.edu (Jeff Stern) writes:

   I have a WD8003E board, and am trying to run NCSA Telnet using the
   packet-driver, but am having no luck.  I load the driver with:

   	WD8003E 0x60 3 0x280 0xD000


   I also have the config.tel file set for
   	hardware=packet
   	ioaddr=60

When you're using hardware=packet, you should delete (or comment out)
all the other lines relating to the hardware, like this:

hardware=packet
# ioaddr=280
# address=D000
# interrupt=3

--
--russ <nelson@clutx.clarkson.edu> I'm proud to be a humble Quaker.
It's better to get mugged than to live a life of fear -- Freeman Dyson
I joined the League for Programming Freedom, and I hope you'll join too.