Path: utzoo!utgpu!news-server.csri.toronto.edu!rutgers!uwm.edu!zaphod.mps.ohio-state.edu!sdd.hp.com!hp-pcd!hpcvra.cv.hp.com!rnews!hpcvbbs!akcs.dmanquen
From: akcs.dmanquen@hpcvbbs.UUCP (derek manquen)
Newsgroups: comp.sys.handhelds
Subject: Re: PC to HP48SX via ProComm
Keywords: ProComm, HP48SX
Message-ID: <28013ddf:2592.1comp.sys.handhelds;1@hpcvbbs.UUCP>
Date: 9 Apr 91 04:40:05 GMT
References: <231b3618.670556614@fergvax>
Lines: 20

I happen to be using Procomm+ with my hp48.  After many hours of figuring
out the proper configuration, I finally got it, and it works beautifully.
Here is the config. that Iam using:
 
    Go to the port/line  settings (alt-P)
    set parameters to N/8/1 (alt-N), 9600baud (5), then the comm port
    that your cable is hooked to (mine is comm1).  If this happens to
    be the same port as your mouse, then you have to re-boot with the
    mouse driver deactivate.
 
    Next, go to the setup menu (alt-s), and switch the connection  type
    parameter to direct (D..then toggle to direct).
 
I dont know is all these steps are necessary, but mine is  working on
them,
and as long as  it works, who cares.
 
Good luck,
Derek Manquen, Michigan Tech Univ.
DCMANQUE at  mtus5.cts.mtu.edu