Path: utzoo!utgpu!news-server.csri.toronto.edu!rpi!usc!orion.oac.uci.edu!jstern
From: jstern@orion.oac.uci.edu (Jeff Stern)
Newsgroups: comp.protocols.tcp-ip.ibmpc
Subject: Re: Post #2: Trying to get WD8003E driver working with Telnet...
Message-ID: <280348FC.1014@orion.oac.uci.edu>
Date: 10 Apr 91 17:18:51 GMT
References: <2800ABE5.26929@orion.oac.uci.edu>
Distribution: usa
Organization: University of California, Irvine
Lines: 14


Hi, all.  Well, these are the results.  Thanks to everyone for your
suggestions, command-lines, and config.tel files.  Since command files
really varied greatly (the only common denominator among ALL of them
was the 'hardware=packet' line!) and from peoples' command lines I
knew I was doing the right thing, the only suggestion left was from a
couple of people who said they had had problems with particular
versions of Telbin.  So I checked... Sure enough, I was using NCSA
Telbin 1.2.  So I downloaded CUTCP 2.2-D from clarkson and ran that,
and *deleted* the ioaddr, interrupt, and addr lines (leaving only the
'hardware=packet' line) from my config.tel file, and as you read, I am
writing to you using the packet driver!  Ah, success!!! Once again,
thanks all.  Jeff Stern.
------------------------->jstern@orion.oac.uci.edu<-------------------------