Path: utzoo!utgpu!news-server.csri.toronto.edu!rpi!zaphod.mps.ohio-state.edu!think.com!mintaka!ogicse!milton!serval!yoda.eecs.wsu.edu!dgustafs From: dgustafs@eecs.wsu.edu (gustafson david s - CS350) Newsgroups: comp.sys.ibm.pc.hardware Subject: Re: Slow switching on NEC 3D Monitor Keywords: 3D NEC TSeng VGA Message-ID: <1991Apr10.001651.186@eecs.wsu.edu> Date: 10 Apr 91 00:16:51 GMT Article-I.D.: eecs.1991Apr10.001651.186 References: Organization: Washington State University Lines: 15 In article u855203@probitas.cs.utas.edu.au (Michael Harlow) writes: >I use an NEC 3D on a 33Mhz 386, attached to a SVGA using TSeng ET4000 >chip set. When the card changes modes (eg from 25 to 43 line or from >25 line text to graphics mode), the screen goes blank for about 3 seconds. I have a similar problem with my NEC 4D. The switch from 80x25 to 1024x768 takes about 1 second usually. And then, about once a week (very unpredictable) it will blank for 1 second, display for about .5 seconds, and then blank again for about 1 second. Very strange. Again, I have a Diamond SpeedStar (Tseng ET4000). Dave -------------------------------------------------------------------------------- David Gustafson - EECS Washington State University - dgustafs@yoda.eecs.wsu.edu --------------------------------------------------------------------------------