Path: utzoo!utgpu!news-server.csri.toronto.edu!rpi!usc!snorkelwacker.mit.edu!stanford.edu!rutgers!bagate!cbmvax!amix!vanth!jms From: jms@vanth.UUCP (Jim Shaffer) Newsgroups: comp.sys.amiga.misc Subject: Re: Boot1.lzh - thanks!, Imploding Arp.lib Message-ID: Date: 23 Apr 91 00:17:10 GMT References: <13242.28107d54@zeus.unomaha.edu> Organization: The Search For TERRESTRIAL Intelligence Lines: 29 In article <13242.28107d54@zeus.unomaha.edu> bacon@zeus.unomaha.edu (Infomaniac) writes: >Imploder3.1 Question > >This program is supposed to implode libraries without any ill effects. H >owever, I decided to implode the arp.library and now on bootup I get an error >message that says .... Arb.library v39+ needed (not sure about ver number) Stupid Question #1: did you have the Library gadget enabled in Imploder? Stupid Question #2: do you have explode.library in libs:? >Also, thanks go to Phil@documail.uucp. He found the Boot1.lzh that I had been >looking for. However, there is one problem with the problem. It does >something to the system timing so that on bootup the system date is: > >. After any warm boots it is the same! (system date is >not preserved). In addition, after running CURE (virus detector and killer) it >frequently reports a "LoadSeg error" and removes the error. What has most likely happened is that some program has stomped on your clock registers. Do a "setclock reset" then "setclock save". LoadSeg() was most likely modified by the explode.library. If you don't run CURE, do you still have the problem of not getting arp.library loaded? -- * From the disk of: | jms@vanth.uucp | "You know I never knew Jim Shaffer, Jr. | amix.commodore.com!vanth!jms | that it could be so 37 Brook Street | uunet!cbmvax!amix!vanth!jms | strange..." Montgomery, PA 17752 | 72750.2335@compuserve.com | (R.E.M.)