Path: utzoo!utgpu!news-server.csri.toronto.edu!rutgers!att!pacbell.com!mips!zaphod.mps.ohio-state.edu!caen!hellgate.utah.edu!fcom.cc.utah.edu!news
From: cryptkpr@cc.utah.edu (H. CARLTON DOE III)
Newsgroups: comp.sys.att
Subject: Pin settings for StarLAN 10MB hub
Message-ID: <1991Apr19.041855.17030@fcom.cc.utah.edu>
Date: 19 Apr 91 04:10:53 GMT
Sender: news@fcom.cc.utah.edu
Reply-To: cryptkpr@cc.utah.edu
Distribution: usa
Organization: University of Utah Computer Center
Lines: 20

I have a 10MB StarLAN hub which I am using with TCP/IP.  I want to hook
up some Emulex terminal servers onto the net but I have a problem--I need
to know what the four active pins (out of the eight) on each port of the hub 
do.  All the manual on the hub says is that two are input and two are output.

I have to build an adapter which will go on the back of the terminal server
using its active pins to channel the server signals to the hub.  Any help
sent via e-mail would be appreciated.

    the Crypt Keeper
    aka Carlton Doe
    at Spectrum Field Services
===========================================================================
                                   |  WARNING!  This is only a test!  Had 
     cryptkpr@cc.utah.edu          |  the above been an insightful or
     cdoe@peruvian.utah.edu        |  original thought rather than a waste
            or                     |  of bandwidth, you would have been told
     attmail!alexis!carlton        |  where to tune in your area for official
                                   |  news and information.  I repeat, this is
                                   |  only a test!