Path: utzoo!utgpu!news-server.csri.toronto.edu!rpi!uwm.edu!wuarchive!sdd.hp.com!think.com!mintaka!bloom-beacon!eru!hagbard!sunic!mcsun!hp4nl!alchemy!ruunfs!muts From: muts@fysak.fys.ruu.nl (Peter Mutsaers) Newsgroups: comp.sys.hp Subject: Re: Porting X11R4 to the HP9000 Series 300 and 800 Message-ID: Date: 20 Apr 91 18:07:47 GMT References: <33292@mimsy.umd.edu> Sender: usenet@fys.ruu.nl (News Control) Organization: Physics Department, University of Utrecht Lines: 17 preetham@ra.src.umd.edu (Preetham Gopalaswamy) writes: >This is probably an old and often discussed subject on this newsgroup but I >shall ask the question anyways. I am porting X11R4 to my HP300 and 800 >machines and I would like to know if there are problems, any changes that I >need to make to the source before I start. There is a single file hp.cf in >the mit/config/ directory. Can I use it without any problems for both kinds >of HP machines ? My machines are both running 7.0. Is is sufficient to Porting?? That has already been done. hpux (7.0 too) is among the already supported systems of X11R4. Just use -- Peter Mutsaers email: muts@fysap.fys.ruu.nl Rijksuniversiteit Utrecht muts@fys.ruu.nl Princetonplein 5 tel: (+31)-(0)30-533880 3584 CG Utrecht, Netherlands