Path: utzoo!utgpu!news-server.csri.toronto.edu!rpi!zaphod.mps.ohio-state.edu!uwm.edu!lll-winken!cert!netnews.upenn.edu!scotty.dccs.upenn.edu!tony
From: tony@scotty.dccs.upenn.edu (Anthony Olejnik)
Newsgroups: comp.sys.mac.misc
Subject: Stupid question on EtherTalk installation
Message-ID: <41830@netnews.upenn.edu>
Date: 23 Apr 91 20:56:54 GMT
Sender: news@netnews.upenn.edu
Distribution: usa
Organization: University of Pennsylvania
Lines: 25
Nntp-Posting-Host: scotty.dccs.upenn.edu
Originator: tony@scotty.dccs.upenn.edu

I have a Mac IIci with sys 6.0.7 installed.
I'm trying to install EtherTalk (v2.0.1).

The EtherTalk installer disk has a minimal system 6.0.3 on it.
The IIci will not boot with the minimal system 6.0.3 on it.

I tried to replace the 'system' and 'finder' files (on the 
EtherTalk installation disk) with the 'system' and 'finder'
files from sys 6.0.7.  However, I ran out of room.  

I also tried using the 'system' and 'finder' files from 6.0.5,
Again, I ran out of room.

Apparently the 'system' and 'finder' files for 6.0.3 are smaller
than the files on 6.0.5/6.0.7.  Because of this, they are able to
fit on the EtherTalk installer disk.

So, how do you install EtherTalk on a Mac IIci?
Am I going about this incorrectly?

Any help would be *GREATLY* appreciated.

Thanks.

--tony