Path: utzoo!utgpu!news-server.csri.toronto.edu!rpi!zaphod.mps.ohio-state.edu!mips!pacbell.com!iggy.GW.Vitalink.COM!lll-winken!sun-barr!rutgers!bobsbox!graphics!bobl From: bobl@graphics.rent.com (Bob Lindabury - SysAdm) Newsgroups: comp.sys.amiga.emulations Subject: Re: Hard Drive drivers for A-Max II Message-ID: Date: 26 Apr 91 18:28:01 GMT References: <21w111w164w@graphics.rent.com> Organization: The Graphics BBS (2D,3D,GIF,Animation) +1 908/469-0049 Lines: 28 bobl@graphics.rent.com (Bob Lindabury - SysAdm) writes: > Huh? With the GVP II hardcards, all you have to do is load up > FastPrep, pick Manual Installation, pick the drive ID of the drive > you want to put an AMAX partition on, rename it to AMAX and then pick > click on the Write button. This will save the Rigid Disk Block with > the new partion named AMAX. I mean rename a single PARTITION to AMAX. If you want multiple AMAX partitions, you can name them as amax1, amax2 and so forth. > When you run AMAX II, it will automatically recognize the AMAX > partion. Very simple. Of course, AMAX will recognize it as not a > Mac formatted drive and ask you if you want to format it. You pick > yes and it will make it Mac format. You then have a single partion > in Mac format on your hard drive and it doesn't affect any of your > other partions. ARGH! All instances of "partion" should be partition. -- Bob The Graphics BBS 908/469-0049 "It's better than a sharp stick in the eye!" ============================================================================ InterNet: bobl@graphics.rent.com | Raven Enterprises UUCP: ...rutgers!bobsbox!graphics!bobl | 25 Raven Avenue BitNet: bobl%graphics.rent.com@pucc | Piscataway, NJ 08854 Home #: 908/560-7353 | 908/271-8878