Path: utzoo!utgpu!news-server.csri.toronto.edu!rpi!zaphod.mps.ohio-state.edu!think.com!spool.mu.edu!cs.umn.edu!uc!noc.MR.NET!gacvx2.gac.edu!hhdist
From: HCLIMER%UTCVM.BITNET@CUNYVM.CUNY.EDU (Harold Climer)
Newsgroups: comp.sys.handhelds
Subject: RE: HP34-C repair
Message-ID: <6B0950DE200073AF@gacvx2.gac.edu>
Date: 1 May 91 23:18:52 GMT
Article-I.D.: gacvx2.6B0950DE200073AF
Lines: 10
Return-path: <@CUNYVM.CUNY.EDU:HCLIMER@UTCVM.BITNET>
In-reply-to: Your message of Wed, 1 May 1991 17:06 CST
To: handhelds@gac.edu

I did something similar to what you describe with an old TI-51 that I keep on
my electronics workbench in my basement. I used a SSMMAALL tipped soldering
iron to solder leads to the circuit board. This is the part where you must be
careful.  Make sure the iron is hot. You don't want to keep it in contact with
the board for very long. Also tin the leads before-hand. Connecting the leads t
o the battery pack is not quite as critical,but you still must be careful.
Good Luck

                                             Harold Climer
                                             Physics Department
                                             U. Tennessee Chattanooga