Path: utzoo!utgpu!news-server.csri.toronto.edu!rpi!zaphod.mps.ohio-state.edu!mips!apple!portal!cup.portal.com!mmm
From: mmm@cup.portal.com (Mark Robert Thorson)
Newsgroups: sci.electronics
Subject: Re: DRAM interfacing problems
Message-ID: <41784@cup.portal.com>
Date: 28 Apr 91 19:21:04 GMT
References: <RTP411w163w@tz.wimsey.bc.ca>
Organization: The Portal System (TM)
Lines: 6

What sort of termination did you use?  It sounds like you're "flashing"
on other addresses.  If you didn't use any termination, try putting 100
ohm resistors in series with the mu'xed address, RAS, and CAS, with the
series resistors located close to the drivers.  Also avoid long lines,
and avoid stubs (i.e. the lines should not have branches, or the branches
should be as short as possible).