Path: utzoo!utgpu!news-server.csri.toronto.edu!rpi!dali.cs.montana.edu!caen!math.lsa.umich.edu!zaphod.mps.ohio-state.edu!unix.cis.pitt.edu!pitt!willett!ForthNet
From: ForthNet@willett.pgh.pa.us (ForthNet articles from GEnie)
Newsgroups: comp.lang.forth
Subject: Finding a Forth for the 8051/8031
Message-ID: <2709.UUL1.3#5129@willett.pgh.pa.us>
Date: 4 May 91 11:48:02 GMT
Organization: (n.) to be organized.  But that's not important right now.
Lines: 24


 Date: 05-01-91 (09:01)              Number: 2061 of 2065 (Echo)
   To: TOM SCHOTLAND                 Refer#: 2031
 From: JACK WOEHR                      Read: NO
 Subj: 8051 FORTH                    Status: PUBLIC MESSAGE
 Conf: FORTH (58)                 Read Type: GENERAL (+)

 -> Has anyone been uploading the code to Bill Payne's 8051 Forth?  I
 -> check for messages about it whenever I log on, and never find any.

         Has anyone been accessing Bill Payne's embedded controller
 forth? You bet they have. Like, between that and FPC Forth it's
 about half my traffic! Wish some o' these cats would upload some
 stuff they are doing and post a few messages :-)

                 =jax=

 NET/Mail : RCFB Golden, CO (303) 278-0364 VESTA & Denver FIG for Forth!
 <<<>>>
-----
This message came from GEnie via willett.  You *cannot* reply to the author
using e-mail.  Please post a follow-up article, or use any instructions
the author may have included (USMail addresses, telephone #, etc.).
Report problems to: dwp@willett.pgh.pa.us _or_ uunet!willett!dwp