Path: utzoo!utgpu!news-server.csri.toronto.edu!rpi!zaphod.mps.ohio-state.edu!pacific.mps.ohio-state.edu!linac!unixhub!stanford.edu!snorkelwacker.mit.edu!thunder.mcrcim.mcgill.edu!clyde.concordia.ca!altitude!matrox!uvm-gen!idx.com!sra
From: sra@idx.com
Newsgroups: comp.sys.ibm.pc.hardware
Subject: Jumpers for Colorado Tape Drive
Message-ID: <1991May6.081851.2262@idx.com>
Date: 6 May 91 13:18:50 GMT
Organization: IDX Corporation, S. Burlington, VT
Lines: 13

I recently picked up a Colorado Tape drive with Firmware rev 40.  Unfortunately
it's just different enough from my other drive.  Can anyone tell me how to
configure the jumpers for a "B" drive.  This version looks (on the edge) like

		xxxxxxxx       xxxxxxxx
        	      1  o o o  3
		      4	 o o o  6

My other drive had 2 rows of 5 pins, not just three.  Thanks, steve

  /------------------------------------------------------------------------\
  >   Steve Alpert (W1GGN)  IDX Corporation    Marlborough, Massachusetts  <
  \--------------------------- sra @ idx.com ------------------------------/